Firmware Upgrade - AerialBox T1050PVR User Manual

Firmware Upgrade

Via USB:
One way to perform a rmware upgrade on your receiver is via USB using the USB port in the back.
To do this just follow the instructions below...
1. Download rmware from www.dishtv.co.nz and follow the intructions on the website.
2. Unplug your aerialBox-Ultra from the power, insert the ashdrive.
3. Hold down the INFO button(or OK button if availible) on the front of the unit while pluging the power back in, keep
the INFO button held down until the unit says USB on the front panel. Then you can let the info button go and let the
unit load the rmware.
The receiver will rst display "Load" and if done correctly the display on the front will show "USB" after about 3 seconds.
On screen at the same time it will present a window headed "Software Update through USB"
If the upgrade has been loaded correctly onto the USB ashdrive it will come up with "SW Image File Reading in
progress... " straight after it displays "Searching USB Memory stick... "
Then to a couple of loading screens which will take about 3 minutes to complete.
If the rmware upgrade was incorrectly place on the USB it will also come up with the "Searching USB Memory Stick... "
message, the di erence is the next message will say "SW Image is not present" it will then quickly display the Flash
Veri cation screen which will last only a few seconds. If this happens double check to see if the rmware les are
correctly in a folder called DISHTV_7167 on your USB drive.
S/W Upgrade OTA:
This is Software Upgrade over the air. This will only work if the upgrade is being
broadcast. It can be selected from the "Installation" option in the Main Menu.
29