Troubleshooting - Strong SRT 8112 User Manual

It is possible to use USB storage devices already formatted in NTFS.
Press EXIT to leave this menu.
7.6.3 DvR Setting
This menu allows you to configure settings for Timeshift, recording and playback.
Select DVR Setting in the Media menu and press ok to enter.
Use pq to move the highlight and tu to change settings.
Timeshift:
Step to:
Timeshift to Record:
PS Record:
Press EXIT to leave this menu.
7.6.4 Remove USB device safely
Select Remove USB device safely from the tools menu and press ok. The receiver will display a
message indicating that you can safely remove your storage device from the receiver.
noTE:

8.0 TRoUBlESHooTIng

There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
Problem
LED indicator not lit
No signal found
18
Select between Auto, Pause or Off. When Timeshift is set to Auto it will
automatically start every time after tuning to a channel. When Timeshift is set
to Pause it will start only after pressing the YElloW/2 button. Select Off to
deactivate Timeshift.
30 sec to 30 min. Set the time step you like to jump forward by pressing 4
during playback of recorded files. This will only work when the info banner is
displayed on screen. If it is not, press InFo.
If set to On the timeshifted part will be included in your recording when you
start to record the current programme.
Select between On or Off. When Off is selected, recordings will also
include subtitles and Teletext (when available). Record to PS mode On
allows recordings without these extras which will need less space on your
USB device.
After performing this function, the USB device is no longer accessible from
your receiver. To gain access to your storage device again, re-insert it or switch
the receiver to standby and on again.
Possible cause
Mains lead unplugged
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
PART 1 • English
What to do
Check mains plug
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna
Power ON/connect external
power