Tools - Strong SRT 8112 User Manual

Timer Service:
Wakeup Channel:
Wakeup Date:
Wakeup Time:
Duration:
When all settings are according to your wishes, use pq to move the highlight to Save and press ok
to confirm. To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 Parental lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press ok to proceed. You will be
asked to enter your PIN code. (DEFAUlT PIn: 1234)
Menu Lock:
Parental Rating:
New Password:
Confirm Password:
7.3.6 oSD Setting
This menu allows you to change settings for:
OSD Timeout:
OSD Transparency:
Load Default OSD Setting:
7.3.7 Auto Standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30 Min/1
Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn't receive any commands during
this time. Set Auto Standby to Off to deactivate the automatic standby function.

7.4 Tools

Press MEnU in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press ok or u to enter.
Use pq to highlight the submenu of choice and press ok proceed.
Press EXIT to leave.
14
day, same time) and Monthly (Timer will be executed every month, same day,
same time).
Choose between Channel (Timer will wake up the receiver) or Record (Timer
will start to record the scheduled event).
Use tu to select the channel the timer will wake up with.
Use the 0~9 buttons to input the date for the timed event.
Use the 0~9 buttons to input the start time.
Use the 0~9 buttons to input the timer duration.
Locks the installation menu. You can set Menu Lock to On or Off.
Choose between: Off, 4 years and up to 18 years. Channels with a parental
rating above the chosen age will be protected with a PIN code (if available in
your local broadcast.)
Enter your new PIN code (4 digits) here.
Re-enter your PIN code here to confirm.
Sets the time after which on screen banners and messages disappear. The
range is 1~10 seconds or Always On.
To set the OSD transparency from Off ~ 40% with 10% steps.
Press ok to clear all OSD settings and reset to default values.
OSD Timeout and OSD Transparency.
PART 1 • English