Advanced Installation Guide
Alternate Wiring
If labels do not match letters on the thermostat, check
the chart below and connect to terminal as shown here
(see notes, below).
B
If wires will be connected to both
terminals, remove metal jumper (see page 6).
Do not use
electrical tape.
If you have a heat pump without auxiliary/backup heat
and your old thermostat had separate O and B
terminals, connect O and do not connect B. Wrap
bare end of B wire with electrical tape.
Place a jumper (piece of wire) between Y and W if
you are using a heat pump without auxiliary/backup
heat.
Thermostat does not work on Heat Pumps with
auxiliary/backup heat.
69-2712EF—01
O
G
Y
C
X
or
. Wrap bare end of wire with
20
4
4
R
and
R
Rc
M32734
Rc