QMD 37x WDR Install Manual page 49

Connect Speed dome to video server
Video server, the contemporary device for conducting surveillance through LAN
and WAN, can also be the controlling tool for this camera.
Most video servers in market are built with RS485 port and one video-in for
connecting one camera. To work with this camera, installer must connect both
signals
(video and RS485)
below.
First of all, the camera ID should be kept on number "0" (zero) or 1 (one) when it
is linked to a video server, unless your video server requires different ID. Be sure
the RS485 polarity is correctly handled. Once the connectivity is completed, start
the video server control panel on computer and follow the instructions on below
during the video server setup

Choose

choose

baud rate matches the setting in camera; "

parity is set to "

Data bit is "

Stop bit is "
You should be able to control to the camera after these are correctly set up. For
advanced functions, follow the instructions given by the video server manual.
.
QMD Install manual D06400210010G PTZ Dome Camera
from the server to the camera, as the picture shown on
Pelco D
as the control protocol
RS485
as the communication format
0
" (zero) or "
8
" (eight)
1
" (one)
2400
None
"
" is recommended
49
.