Power - QMD 37x WDR Install Manual

7.1
The camera has two versions for power: DC12V or AC24V, except the
outdoor housing which works with AC 24V only.
1. DC12V:
When operated with DC12V, the camera may consume 1000mA DC current in
full load condition. To secure the safety and maintain correct function, always
use the 12V / 1.5A DC adapter supplied by the manufacturer.
To power the speed dome is simple. Get the DC jack from the camera, and
connect the adapter plug to the jack.
2. AC24V: (AC adapter of 24V / 1.66A is optional.)
An AC adapter of 24V / 1.66A is supplied with the camera / housing for the AC
version. To power the camera, connect adapter to camera's power connector.
Power Connector on Speed Dome
As soon as power is supplied, the speed dome will enter "initial check" mode, and
automatically run through the following procedures:

Move the lens around automatically for system check and calibration

Then the camera will show normal image and get ready for control
.
QMD Install manual D06400210010G PTZ Dome Camera

Power

AC 24V Connector on Adaptor
DC 12V adapter
(supplied)
41
.