Lexmark 133 User Manual page 225

C
HECK THE DARKNESS
The Toner Darkness setting is too light, the RGB Brightness setting is too light, or the RGB Contrast setting is too
low.
1
From the printer control panel, press
2
From the Admin menu, press the arrow buttons until Settings appears, and then press
3
Press the arrow buttons until Print menu appears, and then press
4
Press the arrow buttons until Quality menu appears, and then press
5
Press the arrow buttons until Toner Darkness, RGB Brightness, or RGB Contrast appears, and then
press .
6
Change the selected setting to a lower value, and then press
T
HE PAPER MAY HAVE ABSORBED MOISTURE DUE TO HIGH HUMIDITY
Load paper from a fresh package.
•
Store paper in its original wrapper until you use it.
•
C
HECK THE PAPER
Avoid textured paper with rough finishes.
C P T
HECK THE APER
Make sure the Paper Type setting matches the paper loaded in the tray.
M C
AKE SURE OLOR
Color Saver may be set to On.
A
TONER CARTRIDGE MAY BE LOW
When 88 <color> Cartridge Low appears, order a new cartridge.
A
TONER CARTRIDGE MAY BE DEFECTIVE
Replace the toner cartridge.
T
HE IMAGING KIT MAY BE WORN OR DEFECTIVE
Replace the imaging kit.
Note: The printer has two types of imaging kits: a black and color imaging kit, and a black imaging kit. The black
and color imaging kit contains cyan, magenta, yellow, and black. The black imaging kit contains black only.
, ,
BRIGHTNESS AND CONTRAST SETTINGS
.
YPE SETTING
S O
AVER IS SET TO FF
Troubleshooting
.
.
225
.
.