Removing The Transducer; Mounting The Unit - Raymarine Dragonfly-4 Installation And Operation Instructions Manual

4.3 Removing the transducer

The transducer can be released from the bracket by
inserting a small metal rod such as a paperclip into
the transducer release hole located as shown.
1. Insert the metal rod into the transducer release
hole.
2. Slide the transducer off of the bracket.
Mounting

4.4 Mounting the unit

The unit is mounted using the bracket provided.
Before mounting ensure that you have:
• selected a suitable location.
• installed the transducer and routed the
power/transducer cable to the selected location.
1
D13189-1
1. Slide the Hex (allen) bolt through the pivot ball,
then slide the pivot ball through the center of the
bracket locking collar.
2. Using a 5 mm Hex (allen) key (not supplied),
screw the Hex (allen) bolt into the underside of
the unit, ensuring the locating tabs are correctly
aligned.
3. Using the fixings provided mount the bracket
base to the mounting surface as follows:
i. Mark the location of the bracket base's
mounting holes on the chosen mounting
surface.
ii. Drill holes for the fixings using a suitable drill,
ensuring there is nothing behind the surface
that may be damaged.
iii. Use a pozi-drive screw driver and an 8 mm
wrench (spanner) to attach the bracket base
securely to the mounting surface using the
fixings provided.
4. Position the unit at the desired angle and secure
by tightening the locking collar.
2
D13191-1
D13192-1
31