The Remote Control System; Remote Control Transmitter - GRAUPNER Hilti Monster Truck 4WD Instruction Manual

If you discover a part in the kit, which is defective concerning material or processing, send it - before you
used it – back to us and we will supply replacement to you.
REQUIRES
To operate your new Monster Truck you will need the following accessoiries:
• 8 alkaline AA batteries for the transmitter (included) and a HILTI Li-Ion Battery pack B 144 2.6 (not inclu-
ded) with a suitable charger C4/36-ACS TPS

THE REMOTE CONTROL SYSTEM

Here you get an overview of the remote control system of the Monster Truck and its various functions and set-
tings. Before the fi rst trip you should be sure all of these functions and settings have read and understood.
First screw the enclosed transmitter antenna into the mounting plate at the top of the transmitter. Place 8 AA
batteries in the battery compartment of the transmitter and a fully charged receiver-pack in the battery box.
Pay attention to the polarity!
REMOTE CONTROL (TRANSMITTER)
1. On / off switch: Turns the power on/off
2. Steering wheel: Controls direction (left/right) of the model
3. Steering trim: Adjusts the "hands off" direction of the model
4. Throttle Trigger: Controls speed (forward/brake) of the model
5. Throttle Trim: Adjusts the motor speed to stop at neutral
6. Control light: indicates adequate battery power
7. Antenna: Transmits signal to the model
The remote control system of the Monster Truck is optimally adjusted by the factory. Nevertheless you should
read the following chapter, maybe slight adjustments on the remote control should be necessary. For further
information to the remote control system please refer to the enclosed XG-6 manual.
90165.RTR Hilti Monster Truck 4WD 08