Table of Contents
Advertisement
Rear Panel
Reset Button
WAN port
(10/100BaseT)
10/100BaseT
LAN connections
Power port
Figure 3: Rear Panel
This button has two (2) functions:
Reboot. When pressed and released, the LevelOne Broadband
VPN Gateway will reboot (restart).
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button down for five (5) seconds, until
the Red Status LED has flashed TWICE.
4. Release the Reset Button. The LevelOne Broadband VPN
Gateway is now using the factory default values.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the LevelOne Broadband VPN Gateway will
automatically function as an "Uplink" port when required. Just
connect any port to a normal port on the other hub, using a standard
LAN cable.
Connect the supplied power adapter here.
Introduction
5
Advertisement
Table of Contents
