Final gear oil
Checking the final gear oil level
1. Place the vehicle on a level surface.
2. Remove the oil filler bolt, and then check
the oil level in the final gear case.
1. Speedometer sensor
3. Correct oil level
NOTE:
The oil level should be at the brim of the filler
hole.
2. final gear oil
3. If the oil is below the brim of the filler hole,
add sufficient oil of the recommended
type to raise it to the correct level.
CAUTION:
1. Be sure no foreign material enters the
final gear case.
2. Please clean the sensor every 500km
period
4. Install the oil filler bolt, and then tighten it
to the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8-14