Jump n Carry JNC300XL User Manual
  1. Manuals
  2. Brands
  3. Jump n Carry Manuals
  4. Remote Starter
  5. JNC300XL
  6. User manual

Jump n Carry JNC300XL User Manual

Portable jump starter/12 voil power source and flashlight
Hide thumbs Also See for JNC300XL:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

See also: Instruction Manual

Advertisement

Table of Contents
loading

Related Manuals for Jump n Carry JNC300XL

Summary of Contents for Jump n Carry JNC300XL

  • Page 2: Safety Information

    Safety Information Read these instructions completely before using the product and save them for future use. Before using the Jump-N-Carry to jump-start a car, truck, boat or to power any ® equipment, read these instructions and the instruction manual/safety information provided by the car, truck, boat or equipment manufacturer.

  • Page 3: Jump Starting

    JUMP-STARTING WARNING Failure to follow instructions may cause damage or explosion, always shield eyes. Read entire instruction manual before use. Turn ignition off before making cable connections • Do not touch RED POS (+) grip to BLACK NEG (–) grip •...

  • Page 4: Recharging Jump-N-Carry

    RECHARGING Jump-N-Carry ® 1) The Jump-N-Carry comes with a wall mount charger. ® 2) Plug the wall charger into any AC outlet. 3) Plug the charger cord into the Recharge Jack on the front of the unit. 4) The right LED will turn on while the charger is plugged into AC power to indicate the unit is charging.

  • Page 5: Performance/Temperature

    PERFORMANCE AND TEMPERATURE Performance of your Jump-N-Carry will depend upon several factors: ® A good solid connection from the Jump-N-Carry grips to the battery and the • ® ground connections are a must. Moving the jumper cable grips back and forth while clamping will help create a better connection.

  • Page 6: Faqs

    Questions and Answers The Jump-N-Carry will not hold a charge? ® Load test battery. Charge battery 24 hours before load testing. Connect load tester to the Jump-N-Carry grips to check battery amperage. Depending on the model of ® load tester your load testing procedure may vary. A generic load test would bring the voltage down to 9.0 volts and result in an amp reading of 70 amps for 6 seconds.
  • Page 7 Express Service and Repair Express Service and Repair will quickly diagnose a problem with your Jump-N-Carry ® To obtain the fastest and most efficient repair of your unit, perform the following steps: 1) If the unit will not jump-start, recharge the unit for 24 hours. 2) If a part is broken or needs replacement, call Express Service for express part delivery.

Table of Contents