Check/Set Distance Of The Magnetic Sensor; Replacing The Battery In The Electronic Speedometer; Replacing The Fan Fuse - KTM 2006 660 SMC Owner's Manual

»
MAINTENANCE WORK ON CHASSIS AND ENGINE

Check/set distance of the magnetic sensor

The distance between the sensor [1] and the magnet [2] must be between 2
and 4 mm. If not, this could cause the speedometer to malfunction.
3
Loosen the counter nut [3] and correct the clearance by screwing the sensor
[1] in or out.
1
2
1
33

Replacing the battery in the electronic speedometer *

A battery is provided to save the speedometer data when the engine is switched
off. If data is lost when the engine is switched off, the battery is dead and
4 must be replaced.
To replace, remove the headlight mask and demount the electronic speedome-
ter. Remove the screw connection [4], insert a new battery (type Duracell CR
2430) with the printed side facing up and mount the screw connection.
Treat the socket connector with contact spray, mount the speedometer and
check for proper functioning.