Connecting The Bluetooth Unit - Kenwood DNX571TR Instruction Manual

Registering the Bluetooth Unit
1
Touch [Search].
Searched Device List screen appears.
NOTE
• You cannot register the Bluetooth unit when you
are using the following sources:
iPod, Bluetooth Audio, APPS, iHeart, Pandora,
AUPEO!
If you want to register the Bluetooth unit while
using one of the above mentioned sources, send
the connection request from the Bluetooth unit
and register it.
• A new device cannot be registered if there are 5
registered Bluetooth units. Delete unnecessary

Connecting the Bluetooth unit

registration. See
(P.83).
• This unit is compatible with the Apple Easy
Pairing function. When an iPod touch or iPhone is
connected to this unit, an authentication dialog
appears. Performing operation for authentication
on this unit or iOS smartphone registers the
smartphone as a Bluetooth device.
• If two Bluetooth units are connected, this unit will
not start the search. In this case disconnect one
of the Bluetooth units.
2
Select the Bluetooth unit to register
from the list.
NOTE
• If the unit cannot be searched in step 1, you can
search the unit again by touching [Search] in
above screen.
• Touch [Cancel] to cancel searching for the
Bluetooth unit.
3
Enter PIN code form the cell-phone.
Profile select screen appears.
Connecting the Bluetooth unit
1
Touch the device name you want to
connect.
Profile select screen appears.
NOTE
• If the icon is lighted, it means that the unit will
use that device.
2
Set each profile as follows.
TEL (HFP)
Means that the device is a cell-phone.
Audio (A2DP)
Means that the device is an audio player or
cell-phone with audio player.
NOTE
• If a device has been paired, the Bluetooth unit
cannot be connected from the paired device.
• Touching [Remove] of [Device Remove Confirm]
removes registration information. After you touch
the key, a confirmation message appears. Follow
the message and complete the operation.
Return to the Top page
Bluetooth Control
83