Table of Contents
Advertisement
Internet Router User Guide
Rear Panel Connectors & Switches
1
Power switch
2
Power port
3
Hub LEDs
4
10BaseT ports
5
10BaseT
uplink port
6
WAN port
7
DIP switches
8
ISDN port
9
Analog tele-
phone ports
12
Electrical switch. IN is ON.
Connect the power adapter here. Use only the unit
provided.
10BaseT port indicators – flash when the hub port
is in use.
Connect 10BaseT cabling here, and the other end
to the PC.
If using both the built-in hub and another hub, use
this port to connect to the other hub.
When this port is in use, port 4 can NOT be used.
Serial port. If using an external modem, connect it
here. See Chapter 9 – Serial Port for further
information.
See the following section.
Use a cable with RJ45 connectors to link this port
to the S/T interface on the NT-1.
If using analog devices, connect them here. See
Chapter 8 – Analog Ports for configuration
details.
Advertisement
Table of Contents
