Problem Solution Result Plug power cord in Remove lens cap No startup screen Correct image Press Power button startup screen Computer image projected Only startup screen appears Press the Computer button Activate laptop’s external port startup screen Restart laptop...
Page 15
Problem Solution Result No computer image, just the words “Signal out of Adjust computer refresh rate in Computer image projected range” Control Panel>Display>Settings>Advanced >Adapter (location varies by operating system) You may also need to set a different resolution on your computer, as shown in the following problem, “Image fuzzy or cropped.”...
Page 16
Set your computer’s display resolution to Image clear and not cropped Image fuzzy or cropped the native resolution of the projector (Start>Settings>Control Panel>Display>Settings tab, select 800x600 for the C40, 1024x768 for C50) For a laptop, disable laptop monitor or turn-on dual- display mode...
Page 17
Move projector, adjust zoom, adjust height Image not centered on screen Correct image zoom Adjust horizontal or vertical position in Picture>Advanced menu Adjust keystone on keypad Square image Image not square...
Page 18
Adjust Sharpness in the Picture>Advanced Correct image Image not sharp menu Change aspect ratio to 16:9 in Correct image Image does not fit 16:9 screen Picture>Aspect ratio menu Turn on/off Ceiling in Settings>System Correct image Image upside down menu...
Page 19
Image reversed left to right Turn on/off Rear in Settings>System menu Correct image Adjust color, tint, color temperature, Projected colors don’t match source Correct image brightness, contrast in the menus COLOR COLOR Make sure vents aren’t blocked, turn off the Lamp won’t turn on, LED blinking red Lamp turns on projector and allow it to cool for a minute...
Page 20
If lamp hours > 2000, lamp must be Lamp won’t turn on, LED blinking red, “Change Lamp turns on lamp” message appears at startup replaced. See page 34. blinks red startup Check lamp hours: screen should be less than 2000 hours in the Main>About menu 7KLV SURGX.W LV ED.NHG E\ D OLPLWHG WZR\HDU ZDUUDQW\ $Q H[WHQGHG ZDU...
Advanced menu Sharpness YLGHR VRXU.HV RQO\ .KDQJHV WKH .ODULW\ RI WKH HGJHV RI D YLGHR LPDJH 6HOH.W D VKDUSQHVV VHWWLQJ Sharpness Advanced menu Color Temperature .KDQJHV WKH LQWHQVLW\ RI WKH .RORUV 6HOH.W D OLVWHG YDOXH RU VHOH.W 8VHU DQG LQGLYLGXDOO\ DGMXVW WKH LQWHQVLW\ RI WKH UHG JUHHQ DQG EOXH .RORU Color Temperature 7KH IROORZLQJ RSWLRQV DUH IRU .RPSXWHU VRXU.HV RQO\...
009-0657-xx Optics Focus Range 4.9 - 29 feet (1.5 - 8.9 m) User’s Guide with CD 010-0363-xx Lamp type 132-watt UHP lamp for C40 150-watt UHP lamp for C50 Safety card 009-0659-xx Color-coded cable ties SP-CABLETIES Input Power Requirements 100-240V 2.5-1 A, 50-60 Hz Ceiling Mount UL tested/listed ceiling mount with minimum capacity of 23 lbs (10.4 kg)
NOTE 8VH RQO\ DSSURYHG D..HVVRULHV Projected image size Optional Accessories Part Number Table 2: Shipping Case (ATA approved) CA-ATA-012 Range of distance to the screen for a given screen size for C40 Samsonite Deluxe Travel Case CASE-802 Distance to screen Diagonal Maximum Minimum 50’...
Page 39
Index Blank 30 Brightness 26 A/V cable, connecting 10 About menu 31 cables accessories included 5 included 5 ordering 37, 38 ordering 37, 38 ceiling projection 29 activating laptop’s external video 7 cleaning Add New hardware Wizard 8 dust filters 33 adjusting lamp housing screens 36 Brightness 26...
Page 41
Phase 28 ratio, aspect 26 Picture in Picture 31 rear projection 29 Picture menu 26 refresh rate 15 PiP 31 registering your projector 5 Power button 22 remote control power cord, connecting 6 intalling batteries 21 Power Save 29 using 21 powering on the projector 7 replacing the projection lamp 34 presentation features 23...
Page 42
Tint 26 Tracking 28 troubleshooting 13 turning off the projector 13 turning on the projector 7 USB mouse, connecting 6 using the menus 25 video device, connecting 10 video image displaying 11 optimizing 24 volume adjsuting 12 zoom 9, 30...
Need help?
Do you have a question about the C40 and is the answer not in the manual?
Questions and answers