Functional Description - Makita 9218SB Instruction Manual

5. NEVER use tool with wood cutting blades or
other sawblades. Such blades when used on a
sander frequently kick and cause loss of
control leading to personal injury.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Make sure the abrasive disc is not contacting
the workpiece before the switch is turned on.
9. When sanding metal surfaces, watch out for
flying sparks. Hold the tool so that sparks fly
away from you
flammable materials.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
12. Check that
supported.
13. Pay attention that the wheel continues to
rotate after the tool is switched off.
14. This tool has not been waterproofed, so do not
use water on the workpiece surface.
15. Ventilate your work area adequately when you
perform sanding operations.
16. Use of this tool to sand some products, paints
and wood could
containing hazardous
appropriate respiratory protection.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
and other persons
the workpiece is
expose user
substances.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
or
003405
properly
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
to dust
maintain firm grasp on tool.
Use
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
USD201-2
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
003410
4
1. Lock button
2. Switch trigger
1
2
1. Side grip
1