Pseudo-Apdus; Direct Transmit; Bi-Color Led Control; Table 30: Direct Transmit Command Format (Length Of The Payload + 5 Bytes) - ACS AET62 Reference Manual

7.

Pseudo-APDUs

•
Pseudo-APDUs are used for the following:
•
Exchanging Data with Non-PCSC Compliant Tags.
•
Retrieving and setting the reader parameters.
•
The Pseudo-APDUs can be sent through the "AET62 PICC Interface" if the tag is already connected.
•
Or the Pseudo-APDUs can be sent by using "Escape Command" if the tag is not presented yet.
7.1.

Direct Transmit

This is the Payload to be sent to the tag or reader.
Command
Direct
Transmit

Table 30: Direct Transmit Command Format (Length of the Payload + 5 Bytes)

Lc: Number of Bytes to Send (1 Byte)
Maximum 255 bytes
Data In: Response
7.2.

Bi-Color LED Control

This APDU is used to control the states of the Bi-Color LED.
Command
Bi-Color
LED
Control
P2: LED State Control
CMD

Bit 0

Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
idvation GmbH
Otto-Hesse-Straße 19 / T5
D-64293 Darmstadt
info@idvation.com
AET62 Reference Manual
Class INS
0xFF 0x00
Response
Direct Transmit

Table 31: Direct Transmit Response Format

Class INS
0xFF 0x00

Table 32: Bi-Color LED Control Command Format (9 Bytes)

Item
Final Red LED State
Final Green LED State
Red LED State Mask
Green LED State Mask
Initial Red LED Blinking State
Initial Green LED Blinking State
Red LED Blinking Mask
Green LED Blinking Mask

Table 33: Bi-Color LED Control Format (1 Byte)

Phone +49 6151 4923021
Fax +49 6151 3689296
www.idvation.com
Version 1.0
P1 P2 Lc
0x00 0x00 Number of
Bytes to send
Data Out
Response Data
P1 P2 Lc
0x40 LED 0x04
State
Control
Description
1 = On; 0 = Off
1 = On; 0 = Off
1 = Update the State
0 = No change
1 = Update the State
0 = No change
1 = On; 0 = Off
1 = On; 0 = Off
1 = Blink
0 = Not Blink
1 = Blink
0 = Not Blink
Data In
Payload
Data In
Blinking
Duration
Control
Page 19 of 37