Hapton Bay Seaport Owner's Manual page 11

Blade Balancing
The following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade arm screws are
secure.
Most fan wobble problems are caused when
2.
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of
one of the blades. Measure from a point on the
center of each blade to the point on the ceiling.
Measure this distance as shown in Figure 13.
Rotate the fan until the next blade is positioned
for measurement. Repeat for each blade.
Measurements deviation should be within 1/8˝.
Run the fan for 10 Minutes.
Use the enclosed Blade Balancing Kit if the
3.
blade wobble is still noticeable.
Touching Ceiling
8
Installing the Mounting
Plate
1. Remove 1 of 3 screws from the mounting ring
and loosen the other 2 screws.(Do not remove)
2. Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 14)
Figure 13
Mounting Plate
Mounting Ring
Screws
Figure 14