Attaching The Fan Blades - Hapton Bay Seaport Owner's Manual

Finishing the Fan
Installation
1. Tuck connections neatly into ceiling outlet
box.
2. Slide the canopy up to mounting bracket and
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 10)
3. Align the circular hole on canopy with the
remaining hole on the mounting bracket,
secure by tightening the two set screws. Note:
Adjust the canopy screws as necessary until the
canopy and canopy cover are snug.
WARNING
MAKE SURE THE TAB ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE IN
THE HANGER BALL BEFORE ATTACHING THE
CANOPY TO THE BRACKET BY TURNING THE
HOUSING UNTIL IT DROPS INTO PLACE.
Screw

Attaching the Fan Blades

1. Attach blades to blade arm using the screws
with rubber washers provided. (Fig. 11) Start a
screw into the blade arm, do not tighten.
Repeat for the 2 remaining screws and
washers.
2. Tighten each screw securely starting with the
center screw. Make sure the blade is straight.
Repeat steps for the remaining blades.
Fasten the blade assemblies to the motor
3.
housing by lining up the slots of the blade arms
with the tabs on the motor housing, then
tighten the two screws already installed in the
blade arms. (Figure 12)
Outlet Box
Ceiling
Mounting
Bracket
Canopy
Blade
Screw
Canopy
Bottom Cover
Figure 10
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE ARMS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NO INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
Screws with
Rubber Washers
Blade Arm
Figure 11
Motor
Tab
Blade Arm
Slot
Screws
Figure 12
7