Advertisement
Example: both controllers set to maximum:
Controller setting:
Display:
Resulting Velocity Curve:
Your personal dynamic settings can be assigned by using „Dyn Store" to the current program
number. (For further details see secondary key functions page 10)
When recalling a previously stored dynamic setting all stored parameters (dynamic and both velocitiy
curves) are automatically set. Therefore the current position of the knobs might not be the one used
by the setting. In this case the LED of the controller in question doesn't light up.
If you twist a controller the recalled settings are changed and the LEDs as well as the display behave
again as mentioned above. The stored settings stay in the memory till you use „Dyn Store" and the
same program number again.
If you want to work with previously stored dynamic settings, push
while turning the controller
Mode
in question till the LEDs light up. Stored data is displayed and the controllers are in tune with your
settings.
Note:
If you want to use your dynamic settings without changing the current program on the sound module,
it is possible to disable the program change. (See secondary key functions page 10 und 16) The display
changes to
with the profile number.
page 7
Manual MK2 V 1_05
Contents
Advertisement
