Advertisement
Example:
Push
and
simultaneously > Hold down "Ped Cal" (g#4) > Enter the required code >
MODE
ON
Release "Ped Cal" (g#4) > Ascending melody for confirmation
The minimum and maximum position of your pedal will be automatically measured and saved when
quitting the secondary piano key function mode by pressing Mode.
Hint:
We recommend pushing the pedals by hand when calibrating as the results will be more accurate, especially if
you only want to calibrate part of the travel range.
Instructions:
Push the pedal to the required minimum. After you let go "Ped Cal" (g#4) the current position is stored as zero
point. Push the pedal now slowly to the desired end setting and hold this position. Store it by pushing
MODE.
.
This also exits secondary piano key function mode
Attention: The longest travel range within a calibration session is stored. Calibrating the pedal again overrides
previous stored values.
Almost any conventional pedal can be used with your FLK. It may be necessary to use a stereo to
mono splitter.
S
YMPATHETIC RESONANCE
When using a sound module with Sympathetic Resonance we recommend disabling Piano Mode. It is
then much easier to play notes with velocity 1 and allow the strings to sound.
USB
, FLK
CONNECTION
DRIVER
Your MK2 keyboard will be displayed as „USB Audio Device" (or similar) under Windows™ and will
work as intended.
To distinguish your FLK keyboard from other MIDI equipment, we recommend installing the FLK USB
driver. Then it will be specified as „FLK USB Midi Interface".
FLK drivers can be downloaded from our website
www.flkeys.at
P
S
OWER
UPPLY
Always use the original FLK power supply. It is suitable for AC voltage 100 V to 240 V at 47 Hz to 63
Hz.
Damages caused by using any other form of power supply are not covered by the FLKeys warranty.
page 18
Manual MK2 V 1_05
Contents
Advertisement
