Roland AR-3000SD Owner's Manual page 24

Troubleshooting
Other Effects
• Reconfirm that the power to the AR-3000SD or
connected device is on.
• Reconfirm that the volume control on the AR-3000SD or
No sound
connected device is turned up.
• Reconfirm that there are no shorts in any connector
cables.
The volume level Could you be using a connection cable that contains a
of the instrument resistor?
connected to LINE IN
Use a connection cable that does not contain a resistor.
jacks is too low.
Sound input to the Mic jack is output from the audio
Sound input to the
output jacks only during recording or recording standby
Mic jack is not output
(REC-In: LINE+MIC-IN). Please be aware that output at
from the audio
times other than recording or recording standby (REC-In:
output jacks
LINE+MIC-IN) is not possible.
• Make sure the power to the AR-3000SD and the LAN
device is turned on.
• Make sure the AR-3000SD is connected to the correct
port of the LAN device.
• Check whether the setting for DHCP has been made on
Unable to connect to
the AR-3000SD.
a LAN device
• If the AR-3000SD is being used with DHCP set to OFF,
make sure the settings for IP ADDRESS and SUBNET
(subnet mask) are correct.
• Check whether the setting for DHCP has been made on
the LAN device.
Depending on the setting for Auto Off, the power is turned
The power turns off
off automatically after no operation has been performed
by itself
for a certain time.
The settings of the internal clock return to their default
values if the power to the unit remains turned off for
The internal clock several days. When the power is turned on while the
was reset
unit is in this default state, the message "Set the clock" is
displayed. If this message appears, set the time and date
again.
24