Playback Using The Panel On The Unit (Manual Playback); Keeping The Output Volume Unchanged (Output Volume Thru); Procedure For Making The Output Volume Thru Setting - Roland AR-3000SD Owner's Manual

Playback Using the Panel on the Unit (Manual Playback)

1.
Insert a card containing recorded data into a slot.
2.
Turn the [SELECT] dial to choose the phrase number to
play.
To switch between card slots CF and SD, press the SELECT dial.
3.
Press the [PLAY/PAUSE] button.
The phrase is played back.
During playback of the phrase, the PLAY indicator lights up.
• During playback of the phrase, pressing the [PLAY/PAUSE]
button pauses audio playback. While playback is paused, the
PLAY/PAUSE indicator flash. To resume playback, press the
[PLAY/PAUSE] button.
• Pressing the [STOP] button ends playback.
• During playback, you can choose the next song to play (without
stopping the phrase being played) by turning the [SELECT] dial.
NOTE
• Note that playback cannot be paused in the following cases:
• Phrase recorded in MP3 or RDAC MODE2 format
• MIDI phrase
• Pattern phrase
• Song phrase
• Dual Mono mode (ON)
• Playback cannot be paused during crossfade, repeat play, or
interval play.
Playback location search
While paused, you can move the current phrase location forward or
backward by turning the [SELECT] dial. To switch the unit of change,
press the SELECT dial. (The units cycle through the sequence of
frame " second " minute " hour " frame.)
Pressing the [PLAY/PAUSE] button again starts playback at the
specified location.
Time shown on the display
During playback or while playback is paused, you switch the time
shown on the display between "Remaining Time (REMAIN)" and
"Elapsed Time" by pressing the [ENTER] button.
Elapsed time
22
3
1 2
Remaining time
Keeping the Output Volume
Unchanged (Output Volume Thru)
This deactivates the [OUTPUT VOLUME] knob and keeps the output
volume level unchanged to prevent accidental operation.
* The OUTPUT VOLUME knob can still be used to adjust the
headphones volume and MONO OUT (Control Input/Output
Terminals) even when Volume Thru is set to "ON. "
Value Explanation
OFF
The Output Volume control is effective.
ON
The Output Volume control is deactivated.
When Volume Thru is set to "On, " the volume is fixed
at the level obtained when the control is centered
(that is, when positioned at 5).
Procedure for Making the Output Volume Thru
Setting
1.
Press the [MENU] button.
The MENU indicator lights up.
2.
Use the [SELECT] dial to choose "9.3 Output Vol. Thru,"
then press the dial.
3.
Turn the [SELECT] dial to choose Volume Thru (OFF or ON),
then press the dial.
4.
When the prompt appears on the screen, press the
[ENTER] button to enable the settings.
To quit without making the settings, use the [SELECT] dial to
choose "NO, " then press the [ENTER] button.
When you're finished making the setting, the display returns to the
setting item selection screen.
5.
Press the [MENU] button.
This ends the setting process and returns you to the usual screen.