First Time Setup
The setup screen will be displayed only when the TV is turned on for the first time and after
the power cord is inserted into a wall outlet.
or
Turn the TV on with the POWER button
(TV)
(Remote)
or
Setup the following items
●
Select your language
●
Select your viewing mode (Be sure to select " Home Use")
If you select " Store Demonstration" by mistake, confirmation screen
will be displayed.
To display the "Set viewing mode" screen again and select "Home
Use", perform "Reset to defaults" in the "Setup" menu.
●
ANT/Cable setup
Select signal type (Over-the-Air/Cable service).
Select Auto Program and start scanning.
Scanning starts.
Note
If at the end of the scanning no channels are found, then check:
1. Antenna's position – or
2. Availability of Cable service
Cable, Satellite or Fiber services with a box are typically connected to
the TV's A/V inputs, preferably HDMI, for best HD picture. In such a
case, the channel scanning is not needed (set "ANT in" to "Cable").
Complete First time setup
Completion screen is displayed.
You can repeat the First time setup
• Press MENU -- > Setup -- > Reset to defaults
To watch TV via a Cable box, Satellite receiver, or any other source
(DVD, DVR, gaming device, etc.), press the INPUT button and select
the appropriate input.
15