Gas And Electrical Specifications - Marshal MB42 Installation & Operating Manual

GAS HOSE RESTRAINT
If the oven is mounted on casters, a commercial flexible connector with a minimum of 3/4" (1.9
cm) inside diamter must be used along with a quick connect device.
The restraint, supplied with the Flexible Hose Kit, must be used to limit the movement of the
unit so that no strain is placed upon the flexible connector. With the restraint fully stretched
the connector should be easy to install and quick connect.
1. Mount the supplied bracket to the hold located on the rear or base frame on the same
side as the gas supply.
The connector must comply with the Standard Connectors for Movable Gas Appliances, ANSI
Z21.59 or Connectors For Moveable Gas Appliances CAN/CHA-6.16 and a quick disconnect
device that complies with the Standard for Quick Disconnect Devices for Use With Gas Fuel,
ANSI Z.41 or Quick Disconnect For Use With Gas Fuel CAN 1-6.9. Adequate means must be
provided to limit the movement of the appliance without depending on the connection and
the quick disconnect device or its associated piping. Adequate means must be provided to
limit the movement of the appliance qithout depending on the connection and the quick
disconnect device or its associated piping.

GAS AND ELECTRICAL SPECIFICATIONS

Models
MB42, SD448, SD1048
MB60, SD660, SD1060
SD236
SD248
SD260
MB866, SD866,
SD10866
WF42
WF60
Input Rate
NATURAL PROPANE
GAS GAS
95,000 90,000
115,000 115,000
50,000 50,000
65,000 65,000
80,000 80,000
115,000 115,000
135,000 135,000
155,000 155,000
Manifold Pressure
NATURAL PROPANE
GAS GAS
4.5 IN. WC 11 IN. WC
4.5 IN. WC 11 IN. WC
4.5 IN. WC 11 IN. WC
4.5 IN. WC 11 IN. WC
4.5 IN. WC 11 IN. WC
4.5 IN. WC 11 IN. WC
4.5 main 11 main
3.5 side 10 side
4.5 main 11 main
3.5 side 10 side
Electrical Requirements
(MB Models Only)
Volts 120VAC
Frequency 60Hz
0.9 AMPS Phase 1
2