Wf Operation - Marshal MB42 Installation & Operating Manual

•
To turn on the side burner, you must first flip the toggle switch (located in the control
compartment) up to the ON position. This will turn on the electronic ignition and light
the pilot
•
Align the red handle valve located on the right side of the control compartment with
the gas line. This will put the side burner at full flame.
• Start with the thermostat set at "5" and the side burner flame on FULL.
•
To shut off the side burner just flip the toggle switch down to the OFF position.
CONTROLLING TOP AND BOTTOM HEAT
• To get the most top heat, the side burner should be on FULL. You can decrease the
amount of top heat by partially closing the valve for the side burner.
•
Adjust the bottom heat by raising or lowering the thermostat knob.
•
Use the thermometer on the right side of the oven to determine the top heat on the
flame side of the baking chamber.
•
**** The heat on the right side of the oven is higher than on the left side. Any part
of the product being cooked that is facing the flames will cook faster and therefore
the products must be spun and watched carefully.
INSTALLATION OF S/S FRONT SHELF AND FRONT HOOD
•
Install the front stainless steel shelf after the cooking surface is installed and cured. Use
the four tec screws provided to secure the shelf to the body of the oven (Note: the shelf
will close the gap between the cooking surface and the front of the baking chamber.
•
If the hood in the front has been removed then reattach by sliding the hood over and
down the screws located in the front of the oven along side the flue.
©2012 Marsal & Sons, Inc. 175 E. Hoffman Ave. Lindenhurst, NY 11757 (631) 226-6688 www.marsalsons.com
WF MODELS
OPERATION
13