Table of Contents
Advertisement
1
I
m
p
o
1
I
m
p
o
N
o
t
i
N
o
t
i
1.1
Safety Warnings
1. Installation of the antenna and transceiver must be contracted to a professional
installer.
2. Read this User Manual and follow all operating and safety instructions.
3. Keep all product information for future reference.
4. This product is supplied with a grounding power plug. Do not defeat this
important safety feature.
5. The power requirements are indicated on the product-marking label. Do not
exceed the described limits.
6. Warning to service personnel: Caution for all AC and DC models – double
pole/neutral fusing. Always replace fuse with correct type and current rating.
7. Position the power cord to avoid possible damage, and do not overload wall
outlets.
8. Do not place this product on or near a direct heat source, and avoid placing
objects on the terminal.
9. Do not operate this device near water or in a wet location.
10. Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
Disconnect the power before cleaning.
11. Protect the unit by disconnecting the power if it is not used for long periods.
12. Locate the terminal on a stable horizontal surface or mount it securely in a 19-
inch Telco rack.
13. The radio transceiver units must not be located near power lines or other
electrical power circuits.
14. The Radio Transceiver must be properly grounded to protect against power
surges and accumulated static electricity. It is the user's responsibility to install
this device in accordance with the local electrical codes: correct installation
procedures for grounding of the transceiver unit, mast, lead-in wire and
discharge unit, location of discharge unit, size of grounding conductors and
connection requirements for grounding electrodes.
70-00042-01-02
r
t
a
n
t
S
a
r
t
a
n
t
S
a
c
e
s
c
e
s
Proprietary Redline Communications © 2005
Installation Guide
BFW
AN-30e & AN-50e Systems
f
e
t
y
&
S
e
f
e
t
y
&
S
e
Page 5 of 34
Chapter
1
r
v
i
c
e
r
v
i
c
e
August 2005
Advertisement
Table of Contents
