G-Lab True Bypass Wah-Pad User Manual page 6

3. - Connect the guitar to the TBWP input IN (plugging in the mono Jack connector
will cause in switching on the power supply of the TBWP and the wah-wah)
and the cable from the amp to the TBWP output OUT (see the diagram from
the page No. 1).
4. - Place your foot on the wah-wah effect (the ACTIV
indicator start to lit meaning the wah-wah effect is
activated), then the wah-wah effect switch set to
active position and block it at this position by the
blocking ring being a part supplied with the TBWP
(this ring eliminates incidental switching off the
wah-wah effect while playing).
Switching on (activating) the wah-wah effect takes place in the moment of
placing your foot on the wah-wah effect and switching off – in the moment of
removing your foot from the wah-wah effect. The wah-wah pedal can be left at any
position.
Switching off the wah-wah effect is performed by True Bypassing the wah-wah effect
what eliminates influence of the electronic wah-wah circuit onto the guitar tone.
4