BOMANN DU 654 G Instruction Manual page 20

NOTE: : : : Recomm NOTE Recommendations for endations for preparation work
NOTE NOTE Recomm Recomm endations for endations for
• When installing, ask another person
• Wear protective gloves to prevent injuries from any sharp edges. Wear protective gloves to prevent injuries from any sharp edges.
• Determine the position of the extractor hood centrally above the hob in Determine the position of the extractor hood centrally above the hob in conformance with the
safety distances.
• Align the drill template horizontally and the drill template horizontally and mark the necessary holes for the wall mountin
spirit level.
• Drill Ø 8 mm mounting holes into the wall and insert the dowel pins. Drill Ø 8 mm mounting holes into the wall and insert the dowel pins.
• Then rotate the mounting screws 2 x ST10 Then rotate the mounting screws 2 x ST10*50 mm in the upper holes as far as
mm from the wall.
• Before suspending the hood, the connecting piece with the non
extractor duct with the screws 4 x ST10*10 mm. extractor duct with the screws 4 x ST10*10 mm.
• Now secure the hood by fixing the mounting
holes.
For extraction mode: For extraction mode:
For extraction mode: For extraction mode:
• Attach the supplied flexible extraction
the connecting piece with non-return valves. C
outside.
• Remove the protective plastic from the telescopic duct. Remove the protective plastic from the telescopic duct.
• Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct
is aligned with the vents (A) at the
• Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner
duct or sliding back into the outer duct. duct or sliding back into the outer duct.
• Attach the mounting rail for the duct cover on the upper duct ending the mounting rail for the duct cover on the upper duct ending. Drill Ø 8 mm mounting holes into
wall and insert the dowel pins. Use the screws 2 x ST10*50 mm to secure the rail. wall and insert the dowel pins. Use the screws 2 x ST10*50 mm to secure the rail.
• For extraction mode, correctly position the flexible For extraction mode, correctly position the flexible extraction hose.
preparation work preparation work preparation work
preparation work preparation work preparation work preparation work
person to assist.
mm in the upper holes as far as these stick out about 20
the connecting piece with the non-return valves must be installed onto the
the mounting screws 2 x ST10*50 mm through the hood body in the lower
extraction hose with an inner diameter of Ø 120 mm onto
return valves. Connect it with the extraction outlet to the
the top.
return valves must be installed onto the
Ø 120 mm onto
extraction outlet to the
Drill Ø 8 mm mounting holes into the
20
formance with the specified
wall mounting. Check them with a
the hood body in the lower