Advertisement
L5QA2/XE, XE2, L7QA2/XE, XE2 GB 2002, 5, 10
INSTALLATION
Dome assembly installation
72 mm φ
(D)
Video Out
Cable
(F)
(H)
Housing
assembly
Viewing
Window
(F)
Housing
(A)
assembly
Dome
assembly
(B)
Security
Screws (4)
Surface Type
Electrical Box
(C)
Foam Gasket
Housing
(F)
assembly
Mounting Screws (4)
Camera/VRB
assembly
3
English
Main unit installation
In-ceiling Type
•
Preparation
Electrical
Make four or more holes in the ceiling or wall for the screws that
Box
are to be used to secure the main unit. If embedding the input
(E)
Input Power
power wire and video out cable, make a hole for these cables to be
Wires
passed through also.
(C)
•
Main unit installation
1
Use the accessory Allen key to remove the four screws (B) that
Foam
Gasket
are securing the dome assembly (A).
2
Insert the foam gasket (C) in between the housing and the
installation surface.
3
Pass the input power wire (E) and video out cable (D) through
(G)
the hole made for that purpose.
4
Align the housing assembly (F) with the screw holes that have
Mounting Screws (4)
been prepared, and then secure it by tightening the four or
more screws (G) (4 mm diameter screws recommended).
5
Determine the lens position in accordance with the location of
the objects to be viewed, and then tighten it in that position.
(Refer to page 4 for lens adjustment details.)
6
Align the viewing window (H) with the lens position.
7
Return the dome assembly (A) to its original position and secure it.
*
(E) Input power wires: 12 V DC 50 Hz
Advertisement
