Teknetics Eurotek Owner's Manual page 4

PRE-ASSEMBLY
Unpack your detector to find the following contents:
1. Control Housing
2. Armrest Assembly with
Screw and Lock-Nut
3. Searchcoil
Tool Required: #1 Phillips Screwdriver
1. • Remove the Screw from the Armrest.
• Slide the Armrest over the end of the S-Rod.
• Attach with Screw and Lock-Nut.
2. Attach Control Housing with 2 screws; install back screw first.
NOTE: The Hand-grip fits under the Control Housing.
Peel back Hand-grip to expose the front hole.
4
4. Middle
Stem
5. Lower Stem
with Bolt &
Knurled
Knob
attached
6. S-Rod with
2 Screws
(attached
with tape)