Lenovo THINKPAD E30 Hardware Maintenance Manual page 78

When installing: Attach the system board so that the battery pins of the system board are attached firmly to
the guide hole of the base cover as shown in
Make sure that the connectors are attached firmly.
Note: Loosen the screws
When installing:
• Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams,
on the part marked a
cause a thermal problem due to imperfect contact with a component. You need to peel the thin film
off from the rubbers
For MT0196 and MT0492:
72
Hardware Maintenance Manual
a
9 , but do not remove them.
9
as in the following figure. Either too much or too less application of grease can
b .
b
in this.
9
10
a
b
11