Kicker SoundStages PWRA211 Manual page 7

37. Reinstall all previously removed parts in reverse order.
38. Run the wire harness along the floor under the rear seats to approximately the middle of the vehicle
and pull the end of the harness under the seat to the cargo area. Fig. 25
39. Set the subwoofer in place and connect the wire harness.
40. Align the mounting bracket with the anchor points at the bottom of the seat and press the enclosure
down until it locks into place. Fig. 13
41. To remove the subwoofer press the tabs on each side of the mounting bracket while lifting up.
Disconnect wiring. Fig. 14
42. Reinstall all previously removed parts in reverse order.
43.1nstall supplied fuses in the fuse holders under hood.
PWRA211 · ©2012 Stillwater Designs 2-22-12 Page 7 of9