Kicker SoundStages PWRA211 Manual page 4

12. Carefully pull the dash panel outward until there is sufficient room to allow access to remove speaker
housing and disconnect wiring.
13. Install the amp/bracket assembly into position as shown in Fig. 11 and secure the top of the amp
bracket using the supplied 1 Omm bolts.
14. Secure the bottom of the amp bracket using the supplied %"screw. Fig. 12
15. Pass
~~e
factory radio
harnes~
0onnecter behind the metal framework indicated by the arrow. Fig . 13
16. Connect the amplifier harness to the amplifier and route the harness up to the radio cavity.
1 7. Connect the male radio harness connecter to the female connecter of the amp harness and tuck this
connection into the void between the radio opening and the instrument cluster to avoid interference
with radio during reinstallation.
18. Route male connector of the amp harness back around the beam as the radio harness originally
was. Fig. 14
PWRA211 · ©2012 Stillwater Designs 2·22-12 Page 4 of9