JARLTECH 2008 Operation Manual page 42

Bar Code Symbologies
Custom Bar Code Identifier
Program
40
The option of changing from the pre-
set letter assignment is also available.
To do this, you must first enable
reading of the "Full ASCII" character
set under the Code 39 configuration.
The programming procedure is then
as follows:
• Scan "Program"
• Scan "Enable"
• Scan the bar code symbology you wish
identify
• Scan the desired characters in the
ASCII Table (maximum 2 digits)
• Scan "Set"
• Scan "End"
The symbology codes are listed on
the following page. The ASCII Code
Table is found in Appendix II.
End