Adjustment - Yamaha PJP-EC200 Setup Procedure

Hide thumbs Also See for PJP-EC200:

voice.

6) While sounds are reproduced from the speakers, check that the CLIP LED

(red) of MIC/LINE INPUT does not turn on. If the LED turns on, turn down

GAIN or speaker output level of your PC or webconference system so that it

does not turn on.

14. Adjust the microphone level of your PC or webconference system.

1) Check the current microphone level by using a sound recorder.

Talk into the microphone and then record your voice using a sound

recorder on your PC.

ii.

Play back the recording to check its sound quality and volume. If the

sound is distorted (by clip), turn down the microphone volume of your

PC. If the volume is extremely low, turn up the microphone volume of

your PC.

2) Adjust the microphone volume of your PC or webconference system to keep

the volume of the audio delivered to the other end at a moderate level.

Adjustment

Execute the auto analyzer.

Press AUTO ANALYZER to start the auto analyzer.

Wait until the auto analyzer ends. The shortest distance between the

speakers and microphone is measured and automatically reflected in the

echo canceller settings. Also, the feedback suppressor settings are

automatically adjusted to the room environment (automatic environment

PJP-EC200 Setup Procedure

Table of Contents