Ring Over Page; Station Message Detail Recording (Smdr) - Samsung DS 616 Technical Manual

HOME
PAGE
DS 616 INSTALLATION
TECHNICAL MANUAL PART 6 JUNE 2002
Table of
Contents
After connecting a common bell, you must assign it to a group in MMC 601 as a ring
destination by using the code for Common Bell.
The basic steps for common bell operation are the following:
a. Wire the loud ringing device to the common bell control contact pair.
b. Program the relay as a common bell in MMC 204.
c. Program the contacts for continuous or steady operation.
d. Program the station hunt group to include the common bell.
e. Assign the trunk to ring the hunt group containing the common bell.
Common bell control can be used with station hunt groups, individual stations and
Universal Answer. Contacts are rated at 24 VDC-1 amp.
WARNING: Do not attempt to connect commercial AC power to these contacts.

6.8 RING OVER PAGE

When a customer-provided paging system is installed, incoming calls can be assigned
to ring over page. Program the line or lines to ring a hunt group. Using MMC 601,
assign ROP as a destination in this hunt group. Ring over page can be used for day or
night operation or both.

6.9 STATION MESSAGE DETAIL RECORDING (SMDR)

(see Figure 6–1)
To receive an SMDR printout, connect a customer-provided printer to one of the serial
interface connectors (DB9) on the SIO2 option board (see Figure 3–2). In order to
prevent damage to the external device or the DS 616 system, before connecting
the printer or the call accounting device, ensure that the system power is turned
OFF. Any external battery, if installed, should also be removed.
Use a pin to pin RS232C cable (see Figure 6–1 for cable pin-outs). When the printer or
optional call accounting device needs to be more than 15 feet away from the system,
shielded computer cable is required. Connect a male DB9 connector to the SIO2 board
and then connect the other end of the cable to the printer or the call accounting device,
utilizing the appropriate connector type. The cable must not exceed 300 meters.
Use MMC 725 to set SMDR print options and MMC 804 to set the transmission
parameters and the SIO2 port to be used.
6.3