Chap 3 System Programming; Before Programming; Basic Command; Enter Into System Programming Status - C-Tel CPS-Z User Manual

3.1 Before programming

All the programming must be carried out on the extension 11, 12, 13, 14; all the programming must
●
be into system programming status.
All the extensions must be of dual tone multi-frequency phone.
●
You are allowed to operate one by one, and end the process by simply pressing #. You don't have to
●
hang up if something wrong occurs, you could press * to restart.
If programming-extension (11,12,13,14) is in Direct-Dialing-Out mode, you need to press * to enter
●
the internal system, then start programming.
When the setting is finished, a long beep indicates that the setting is done correctly and saved in the
●
system. If instead an array of short chirps is heard, that would indicate an error occurred in the setting.
You need to check it out and reset the system. It is only after the end of the long beeps you can
continue another system operation.
You must use "enable C.O. lines" command according to the actual trunk lines before using this
●
product, if you don't enable any C.O. line, the system will consider there is no C.O. line and doesn't
auto detect C.O. line (In default setting: 108 is in Enable status;206/308 are in Disable status)
How to programming
At first you must according 3.2.1 instruction enter into system programming status, and then you can
begin to program as the following instruction.

3.2 Basic Command

3.2.1 Enter into System Programming Status

Format: # *
Example: For programming the system, you should enter # * first.
1. You are required to dial: *#* in the Direct-Dialing-Out mode.
2. In default setting, 108 is Direct-Dialing-Out mode and 206/308 is Indirect-Dialing-Out mode .
3. Programming telephone is EXT11, or EXT.12, or EXT.13, or EXT. 14

Chap 3 System programming

7