Table of Contents
Advertisement
Introduction
Make sure to perform the adjustment by the USB ADJ Tool "adj03SSAW.exe" when replacing the lens
unit or the PCB.
Here the necessary software, driver and setting are explained to use "adj03SSAW.exe".
Note that the tool, drivers etc. are available only for Windows.
1. Preparation
1-1. Prepare the necessary software, driver and DLL file.
1) Prepare the following three files.
• Common test driver for CASIO/PENTAX
[testmode_pentax_casio] folder
• ADJ tool, USB DLL and ADJ setting file
[adj03SSAW] folder
* Place all files in the same folder.
2) Place the common test driver for CASIO/PENTAX in an appropriate place.
3) Place all of ADJ tool, USB DLL and ADJ setting file in the same folder.
1-2. Set the camera so that it recognizes the USB test mode.
1) Enter the test menu.
Turn the power on while pressing both [DISP] and [UPPER].
Press [DOWN], [DOWN], [DISP] and [MENU].
2) Move the cursor to "3: USB TCC TEST" and press [SET].
3) Move the cursor to "1: USB TCC ON" and press [SET].
4) The USB test mode flag is now saved in the camera. Turn the power off.
5) When the USB test mode flag is ON, the test menu appears first when the camera power is turned on.
* When turning the USB test mode flag OFF, set "2: USB TCC OFF" in the test menu.
1-3. Install the USB driver for the USB test mode in the computer.
(The following is an example using the Windows Me.)
1) Prepare the USB driver for the USB test mode.
2) Turn the camera power on which is set in the USB test mode as shown in 1-2 and let it enter the USB
test mode directly (the test menu appears right after the power is turned on).
3) Connect the camera in the above status to the computer by the USB cable.
4) The "Add new hardware" wizard appears.
5) Check "Designate the place for the driver (for users with sufficient knowledge)" and press "Next".
6) Check "Search for the optimum driver for the device (recommended)".
7) Check "Designate the place to search", designate the place which contains "inf" file in the driver by
pressing "Reference" button, and then press "Next" button.
8) When "Universal USB Driver (VMEM manufacturer's name)" appears upon message "Searching for
the driver file for the following devices", press "Next" button.
ADJ TOOL
uusbd.dll
uusbd.inf
uusbd.sys
adj03SSAW.exe (ADJ tool itself)
uusbd.dll (USB DLL)
*.adt (ADJ setting file. Sorted by models)
— 10 —
Advertisement
Table of Contents
