Table of Contents
Advertisement
5. Full setup details
5.1. Main menu
When in monitoring mode, the main menu is accessed by pressing the
ESC button.
The UP and DOWN buttons are used to browse through the main
menu:
1 Monitoring
2 Device information
3 Test operation
4 Control parameters
5 Load set
6 Device parameters
7 Device password
8 Charge mode
9 Factory reset
10 Failure information
11 Meter parameters
The OK and ESC buttons are respectively used to enter or exit the
corresponding pages of the menu items.
A password must be entered to change settings.
When on a settings page, press OK to access the password page and
fill in the password to enable changing of settings.
The default password is 000000
5.2 Device information
The charge controller model, ratings and serial number are displayed
(press the DOWN button to display the serial number).
5.3 Test Operation
When the load output is set on manual control (default setting, see
section 5,5), the output can be switched ON or OFF with the orange
switch button on the Charge Controller. The low voltage cut-off is also
operational.
8
Advertisement
Table of Contents
