Installation Instructions - Celina MASTER SERIES Product Manual

Set Up Instructions
1. Lay out the frame parts on the ground in the approximate location that they will be when the frame is assem-
bled. (See parts / minimum staking layout diagram)
2. Place the 6-way crown in the framework; the protrusions on the crown will alternate between lifted and
touching the ground when it is laid on a level surface. All lifted protrusions will point to the hip rafters, angled
toward the corners of the tent. The protrusion parallel to the ground will point toward the other 6-way crown.
3. Connect the 6-way crown to the hip rafters (14'4" red):
a. Each protrusion on the crown has two holes; one closer to the center (the alignment hole) and one
further down the protrusion (the placement hole).
b. Place a pin in the alignment hole; this keeps the rafter from moving too far onto the crown. Slide the
tubing onto the protrusion until it meets the pin.
c. Align the placement hole in the crown with the hole in the rafter and insert a pin.
d. Remove the alignment hole pin. (*This procedure applies to all frame fittings)
4. Connect the rest of the tubing in the following order:
a. Rafters (10'6" green) to first 6-way crown
b. Spreader (9'4" white) to the first 6-way crown, second 6-way crown to the other end
c. Hip rafters (14'4" red) to the second 6-way crown
d. Rafters (10'6" green) to the second 6-way crown
e. Corner fittings to hip rafters (14'4" red)
f. Side tee fittings to rafters (10'6" green)
g. Spreaders (9'4" white) to side tee fittings
h. Spreaders (9'4" white) to corner fittings
5. Bolt the crown adapters into the 6-way crowns.
a. Insert a bolt through the three holes on top of the adapter.
b. Place the adapter through the center circle of the 6 way crown.
c. Slide the ring assembly over the bottom of the adapter, lining up the bolts through the holes in the ring.
d. Secure the ring adapter by attaching the nut and lock washers to the bolts.
e. Repeat with other crown adapter.
6. Fasten the loop strap (B) around the fitting at each leg location.
20' x 30' Master Series High Peak Frame Tent

INSTALLATION INSTRUCTIONS

www.GetTent.com / www.CelinaTent.com © 2013 Celina Tent Inc.
PG.8