Celina MASTER SERIES Product Manual page 9

7. Roll out a drop cloth to protect the tent top of dirt and abrasions next to the frame and unroll the tent top
pieces. The tent needs to be laid out in the sequence of: 20x10 lace end, 20x10 midsection, 20x10 grommet
end. (The midsection has a lace and grommet side; each seam requires one lace line and one grommet line for
fastening.)
8. Lace the tent together:
a. Line up each tent sections (the lace end will always be on the bottom) so that they overlap.
b. Starting in the middle and working toward the edge pull the first lace up through the first small
grommet. Pull the second lace up through the second grommet, then through the loop of the first lace.
c. While lacing the tent, be sure to connect the rain flap to the rope covering the lace line. This
eliminates the need to crawl on the tent after it has been laced.
d. Continue in this fashion until the third grommet from the edge of the tent is reached. The third lace
should be twice as long as the other loops (this is referred to as a double loop).
e. Pull the final two lines through the grommets and loop the second lace from the tent perimeter
into the first lace (the lace is now going towards the direction of the double loop). Pull the third lace
(double loop) through the second loop. The third lace (double loop) should now be strung through 2
loops (the second loop and the fourth loop).
f. Tie off just past the third grommet; this secures the entire lace line.
g. Connect the hook and loop located on the valance section at the end of each lace line.
h. Repeat this method to secure all other lace lines.
9. Pull the tent top over the frame, lifting up on the fabric or "flapping" it to create a cushion of air. Be careful
not to snag the tent top on the center pole pin. Make sure the tent top is centered.
10. Loop the perimeter cord around the outside post of each corner.
20' x 30' Master Series High Peak Frame Tent
INSTALLATION INSTRUCTIONS
www.GetTent.com / www.CelinaTent.com © 2013 Celina Tent Inc.
PG.9