Taking Measurement; Evaluating Results - Beurer BC 44 Instruction Manual

• Do not inflate the cuff unless wrapped around wrist.
• If no button is pressed for approx. 1 minute the automatic
shut off function shuts off the unit in order to preserve the
batteries.
• Do not touch the unit and cuff and/or press any buttons
when measurement is in progress, except for stopping the
measurement. Doing so may cause incorrect readings.

5.4 Taking Measurement

NOTE:
If you are using the unit for the first time, please remove the
protective film from the display.
• Put on the cuff around your bare left wrist as described
previously and assume the position in which you want to
carry out the measurement.
• Start the blood pressure monitor with the start/stop but-
ton . A beep and a brief display of all the symbols con-
firm that the device is switched on.
• Before the measurement, the last saved test result is briefly
displayed. If there is no measurement in the memory, the
instrument always displays the value "0".
• The cuff is pumped up to 190 mmHg. Cuff air pressure
is released slowly, the pulse symbol
the pulse is measured. As the cuff deflates, decreasing
numbers appear on the display.
If a tendency towards high blood pressure is already de-
tectable, the cuff is pumped up again and cuff pressure
• After the pressure has been completely reduced, the sys-
• Measuring can be interrupted at any time by pressing the
• "Er_" appears if it has not been possible to perform the
• The test result is saved automatically.
• To switch off press the start/stop button
Wait at least 5 minutes before taking another measure-
ment.

6. Evaluating results

•
g
is flashing and
14
increased further. The pulse symbol
as a pulse is found.
tolic pressure, diastolic pressure and pulse readings are
displayed.
start/stop button .
measurement properly. See section 8. on error messages/
troubleshooting and repeat the measurement.
forget to switch off the device, it switches off automati-
cally after approx. 1 minute.
WARNING:
This product does not and is not intended to provide a
medical diagnosis. Measurements results are for refer-
ence only. Self-diagnosis and treatment, e.g. regarding
medication, using measured results represent a risk for
your health. Always consult with a licensed physician
for determination of appropriate medication and dos-
flashes as soon
again. If you