Table of Contents
Advertisement
Auto Tracking Control System
This function automatically adjusts the tracking to match the
recorded tape. Auto tracking engages in the following
cases:
When you insert the cassette and begin playback.
l
When you press CHANNEL A and v at the same time.
l
*When the VCR has been playing back an unrecorded
section of tape, and then reaches a recorded tape
segment.
When auto tracking engages, " b" on the TV screen flashes for a few seconds.
* When a poorly recorded tape is played back, auto tracking may not operate normally. In this event, manually adjust the
Auto Head Cleaning System
When the tape is inserted or ejected, this system automatically cleans the drum and heads with a special
roller before recording or playback begins, protecting the heads and drum from dirt and preserving beautiful
picture quality.
Quick Start with Full Loading Mechanism
Your VCR has a standby function (Full Loading Mechanism) to allow immediate recording and playback.
After pressing REC or PLAYIXS, it takes about 2 seconds until recording or playback is engaged when in the
standby mode.
Auto Rental Mode
(This function only works when AUTO RENTAL mode on the MODE selection screen is set to ON.)
The convenient auto rental mode lets you enjoy playback with ease. When you insert a cassette with the
erasure protection tab removed (rental videos, etc.), your VCR automatically turns on the power, winds the
tape forward to find the recorded section, and plays back the tape. When the tape reaches the end of
recorded section, the VCR automatically rewinds the tape, ejects it and turns into POWER STANDBY mode.
If there is more than a 15 second unrecorded sectron between recorded sections, the tape will automatically stop and
l
rewind. To watch the next recorded section, press STOP fast
If the erasure protection hole is covered, press PLAY/x2 after the power turns on automatically. (Auto Rental Mode does
l
not work.)
The AUTO REPEAT mode has priority over the AUTO RENTAL mode. If the AUTO REPEAT mode is set to ON and the
l
video cassette reaches its end, the VCR will rewind the tape and play it back again without ejecting the tape or turning
into POWER STANDBY mode
Blue Back
Set the BLUE BACK mode to AUTO on the MODE-selection screen. (See Mode
function eliminates monitor noise and mutes sound during playback of unrecorded portions of a tape, and
when receiving a non-broadcasting channel. A blue screen will also appear if the VCR is set to the Auxiliary
input (LINE IN) mode but no video signal is fed to the VCR. (The BLUE BACK mode is set to AUTO at the
factory.)
Blue Back does not function during still picture and video search
l
Blue Back may not function properly if the broadcast signal is too strong or too weak
l
Blue Back cannot be recorded.
l
If the antenna signal is weak while recording a TV programme, or if the input signal is weak while tape dubbing, the
l
monitor screen may turn blue back since the unit may not recognize whether or not a proper signal is being received. In
this event, set the BLUE BACK mode to OFF.
Full Auto Playback
(This function only works when AUTO RENTAL mode on the MODE selection screen is set to OFF.)
Full Auto Playback lets you enjoy playback with ease. When you insert a cassette with the erasure protection
tab removed, your VCR automatically turns on the power and plays back the tape. When the tape reaches its
end, the VCR automatically rewinds the tape, ejects it and turns into POWER STANDBY mode.
If the erasure protection hole is covered, press PLAY/x2 after the power turns on automatically.
l
Poor tracking
forward to that section and play the tape.
Normal tracking
on page 15.) This
19
Hide quick links:
Advertisement
Table of Contents
