Panasonic CF-19 Operating Instructions Manual page 19

n Starting Up
The date and time are incor-
rect.
[Executing Battery Recali-
bration] screen appears.
[Enter Password] does not
appear when resuming from
sleep/hibernation.
Cannot resume.
l Make the correct settings.
A Open the Control Panel.
1. Perform either of the following procedures.
Ÿ Right-click
Ÿ Click on the Start screen.
2. Click [Control Panel].
Click (Start) - [Control Panel].
B Click [Clock, Language, and Region] - [Date and Time].
l If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (è page 30).
l When the computer is connected to LAN, check the date and time of the server.
l The 2100 A.D. or later year will not be correctly recognized on this computer.
l The Battery Recalibration was canceled before Windows was shut down last time. To
start up Windows, turn off the computer by the power switch, and then turn on.
●
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility
( è Reference Manual "Setup Utility").
●
The Windows password can be used instead of the password set in the Setup Utility.
A Add a password.
1. Display "Charm" and click
2. Click [Sign-in options], and click [Add] under "Password".
1. Click (Start) - [Control Panel].
2. Click [User Accounts and Family Safety] - [Add or remove user accounts].
B Set up the following.
1. Open the Control Panel, click [System and Security] - [Power Options] - [Require
a password on wakeup].
2. Add a check mark for [Require a password].
1. Click [Control Panel] - [System and Security] - [Power Option] - [Require a pass-
word when the computer wakes] and add a check mark for [Require a password].
l One of the following operations may have been carried out. Slide the power switch to
turn on the computer. Data not saved will be lost.
Ÿ In sleep mode, the AC adaptor or battery pack was disconnected, or a peripheral was
connected or disconnected.
Ÿ The power switch was slid for four seconds or longer to forcibly turn off the computer.
l An error may occur when the computer automatically enters the sleep or hibernation
mode while the screensaver is active. In this case, turn off the screensaver or change
the pattern of the screensaver.
at the bottom left corner of the Desktop screen.
- [Change PC settings] - [Accounts].
19