Panasonic CF-19 Operating Instructions Manual page 16

Installing Software
15 Perform the "First-time Operation" (è page 9).
NOTE
The date and time, and the time zone may not be correct. Be sure to set them correctly.
l
16 Start the Setup Utility and change the settings as necessary.
17 Perform Windows Update.
18 <Only for model with TPM> Clear TPM (è page 14).
n Using Recovery Disc
Use the Recovery Disc in the following conditions.
Ÿ You have forgotten the administrator password.
Ÿ Installation is not complete. The recovery partition in the hard disk may be broken.
<Only for Windows 7 downgrade model>
Ÿ
To change OS from Windows 7 to Windows 8.1, or vice versa.
NOTE
To change OS from 32 bit to 64 bit, or vice versa, install OS using the recovery partition in the hard disk.
Ÿ
Preparation
l Prepare the following items:
Ÿ Recovery Disc (è
Ÿ USB DVD drive (optional) (refer to recent catalogs and other sources for information about the products
available)
l Remove all peripherals (except for the USB DVD drive).
l Connect the AC adaptor and do not remove it until installation is complete.
1 Connect the DVD drive to the USB port.
2 Start the Setup Utility.
A Display "Charm", and click
B Click [Restart now] under "Advanced startup".
C Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and press F2 or Del while [Panasonic] boot screen is displayed.
l If the [Panasonic] boot screen is not displayed, turn on the computer while holding down F2 or Del .
l If the password is requested, enter the Supervisor Password.
3 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter .
4 Check the [UEFI Boot] setting of the Setup Utility.
[UEFI Boot] should be set to as follows.
When the recovery disc for Windows 8.1 is used : [Enabled]
When the recovery disc for Windows 7 is used : [Disabled]
5 Set the Recovery Disc into the DVD drive.
6 Press .
F10
At the confirmation message, select [Yes] and press Enter .
Computer will restart.
7 Press or
F2 Del
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
8 Select the [Exit] menu, then select your DVD drive in [Boot Override] and press
The computer will restart.
9 Click [Reinstall Windows] and click [Next].
10 At the confirmation message, click [YES].
11 At the License Agreement screen, click [Yes, I agree to the provisions above and wish
to continue!] and click [Next].
16
Reference Manual "Recovery Disc Creation Utility")
- [Change PC settings] - [Update and recovery] - [Recovery].
while [Panasonic] boot screen is displayed.
.
F9
Enter
.