Assembly; Sub Table (Back); Slide Table; Overview Of Table Saw Blade Guarding System - Makita MLT100 Instruction Manual

This tool is provided with the sub table (R) on the right
side of the main table. To use the sub table (R), loosen
two screws on the right side counterclockwaise, pull out
the table (R) fully and then tighten the two screws.

Sub table (back)

1
2
008768
To use the sub table (back), loosen the screws on the left
and right hand sides under the table and pull it out
backwards to the desired length. At the desired length,
tighten the screw securely.

Slide table

1
009707
This tool is provided with the slide table on the left side.
The slide table slides back and forth.
Hold workpiece firmly with the miter gauge using a
clamp on the miter gauge and slide the workpiece
together with the slide table at the time of cutting
operation.

ASSEMBLY

Overview of Table Saw Blade Guarding
System
1
2
3
4
009912
1. Screws
2. Sub table (back)
1. Slide table
1. Table saw blade
guard assembly
2. Antikickback pawls
3. Riving knife / spreader
4. Riving knife /
spreader release
lever location
5. Table saw blade
5 side guards
WARNING:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
The saw blade and blade guard are not installed on the
tool when it is shipped from the factory.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
3
009892
Remove the table insert on the table. Hold the outer
flange with the wrench and loosen the hex nut
counterclockwise with the wrench. Then remove the
outer flange.
Assemble the inner flange, blade, outer flange and hex
nut onto the arbor, making sure that the teeth of the
blade are pointing down at the front of the table. Always
install the hex nut with its recessed side facing the outer
flange.
1
006136
CAUTION:
Keep the flange surface clean of dirt or other
•
adhering matter; it could cause blade slippage. Be
sure that the blade is installed so that the teeth are
aligned in the cutting (turning) direction.
7
1. Wrench
2. Hex nut
1
3. Wrench
2
1. Inner flange
2 4 2. Outer flange
3. Saw blade
4. Hex nut
3