Keypad; Numeric Entry Method - Symmetry PR series User Manual

7.0 KEYPAD

The keypad has the following keys to operate the balance.
Keys
[On/Off]
[Tare] or [Esc]
[Cal] / or
[Up]
[Print] /  or
[Back]
[Setup]/
or [Enter]
[Mode] / or
[Advance]
[Units] / or
[Down]
[Mode] / or
[Advance]
7.1

NUMERIC ENTRY METHOD

To set a value when required, use the keys as given below-
- [Up] and [Down] keys to increase or decrease the flashing digit,
- [Advance] and [Back] keys to advance or move back the digit and
- [Enter] key to accept the value
Primary function
To turn the balance to ON or
OFF
A combined zero and tare
function
Starts the calibration function
Instructs the balance to print
data
Enters a function
Selects functions by cycling
through a set of enabled
functions, for example parts
counting or percent weighing
Selects weighing units by
cycling through a set of
enabled units
Selects functions by cycling
through a set of enabled
functions, for example parts
counting and percent weighing
Secondary function
-
To escape from setup
functions and modes
To increment or change a
displayed value or scroll
through options forward
To advance a flashing digit
by one position to the left
To save a value during
setting up a function such
as entering unit weight
To advance a flashing digit
by one position to the right
To go back by one step
during setup functions
To decrement or change a
displayed value or scroll
through options backwards
To advance a flashing digit
by one position to the right
To go back by one step
during setup functions
P.N. 8190, Revision A1, September 2006
Page 9 of 32