Virtualdj - Midi Controls; Hotcues Mode - Reloop RP8000 Operation Manual

B. VirtualDJ - Midi Controls
The RP-8000 is offering 4 individual MIDI channels and those are pre-defined to control 4
separate VirtualDJ decks. Each RP-8000 unit can be assigned to a MIDI channel/deck as
following:
- Hold down the TRAX (9) encoder for approximately 3 seconds.
- The LCD Display will then indicate the selected MIDI channel
- Turn the encoder to select a MIDI Channel (1 to 4) or use Pads 1 to 4
9. TRAX ENC/PUSH. Use the encoder to scroll through the tracks of the Songs List.
Push the encoder to load the selected track from the Songs List to the assigned
deck.
Push the encoder and then turn the encoder slightly to set focus to the folders list.
You can then release the TRAX button and use the encoder to scroll through
folders.
Push the encoder again to set the focus back to the Songs List.
10. PAD MODE SEL. Use these buttons to set the PADS (11) to one of the available Pad
modes
11. PADS. The 8 Pads offer different functionality, depending on the selected Pad mode
as explained below

HotCues mode

Press the CUE mode button to set the PADs to HotCue mode
(led will turn on blue)
Each one of the 8 pads assigns a Hot Cue Point (1 to 8) or
returns the track to that Hot Cue Point.
When a Hot Cue Button is unlit, you can assign a Hot Cue Point
by pressing it at the desired point in your track. Once it is
assigned, the Hot Cue Button will light up.
Hold the CUE button down and then press any of the pads to
delete its assigned Hot Cue Point.
VirtualDJ 8 – Reloop RP8000
8